How to find a roof leak
Start inside the house, and stay off the roof. A wet, mossy pitch is slippery, and WorkSafeBC requires roofers to use fall protection anywhere a fall of 3 metres or more is possible. The inside of your house tells a roofer most of what they need anyway. Look for:
- Ceiling stains with brown or yellow rings, usually on the top floor, near a chimney, a bathroom fan or under a valley
- Bubbling or peeling paint where a ceiling meets an outside wall
- Drips at light fixtures, fan grilles or around the attic hatch
- A musty smell in top-floor closets
- Stains that only show up when wind blows from one direction, which points to wind-driven rain at flashing or under lifted shingles
Water rarely drips straight down from the hole. It runs along the underside of the roof boards and down the rafters before it falls, so the stain on your ceiling can sit well away from where the water gets in.
Checking the attic, only if it's easy
If your attic hatch is reachable from a stable stepladder indoors, a flashlight look can help. Stay on the hatch frame or the framing; never step onto insulation or the ceiling between joists. Look for dark stains on the underside of the roof boards, wet or matted insulation, and rusty nail tips. If the hatch is in a closet shelf or a tight crawl, leave it for us.
Not every damp attic is a leak. RDH Building Engineering's 2015 field study of Pacific Northwest roofs found the underside of roof decks getting wet in winter from outdoor conditions and night-sky cooling, even with indoor moisture sources removed. Damp spread evenly across the attic, rather than one concentrated stain, points toward condensation and not a hole in the roof.
What to do while you wait
Contain the water indoors and record what you see. That protects your belongings and shortens the search later.
- Put a bucket or bin under the drip, with a towel in the bottom to stop splashing.
- Move furniture, rugs, electronics and boxes out of the wet area, and lay plastic over anything too heavy to move.
- If water comes through a light fixture, stop using it and switch that circuit off at the panel if you can reach the panel safely.
- If a ceiling sags or bulges, keep people and pets out from under it.
- Photograph the stain, then trace its edge in pencil with the date. If it grows in the next rain, the leak is active.
- Write down the date, the weather and the wind direction each time it leaks. That narrows the search more than anything else.
Then send the quote form with your photos, and we reply within one business day. We open roofs only in dry windows, because opening one in the rain lets in more water than it keeps out.
Leak inside? Send us what you are seeing. We reply within one business day.
Get a written quoteWhere South Island roofs usually leak
IKO's installation guide puts it simply: a roof most likely leaks wherever the shingle layer is penetrated, interrupted or meets a wall. On Greater Victoria houses, that comes down to a short list.
| Leak point | What usually fails | What you notice inside |
|---|---|---|
| Chimney and wall flashing | Step flashing (small bent metal pieces woven into each shingle course along a wall) lifts or rusts, or the joint was caulked instead of covered with counterflashing | Stains on the ceiling or wall beside the chimney, often worse in wind |
| Plumbing vent pipes | The rubber collar around the pipe, called a vent boot, cracks with age and sun | A small round stain below the pipe, often near a bathroom |
| Valleys | Where two slopes meet, water concentrates; worn shingles, debris or moss push it sideways under the edges | Stains in inside corners of rooms below the valley |
| Wind-lifted shingles | Tabs that never sealed, or lost their bond, lift in winter storms and let rain blow under | Leaks in storms from one direction, dry in calm rain |
| Roof vents and fan outlets | Cracked housings, loose fasteners, or no membrane around the opening | Drips at a bathroom fan grille or a damp patch near the vent |
| Eaves | Water held at the edge by moss, debris or a missing drip edge (the metal strip along the roof edge) | Stains along outside walls at the ceiling line |
IKO's ice and water protector bulletin calls for membrane around vent pipes, chimneys and along walls, under the flashing. Older roofs may never have had it, and a caulk-only patch doesn't add it, so we rebuild those spots instead of sealing over them.
Repair or replace: how we decide
We'd rather fix the spot that's failing than sell a roof that isn't finished. A repair makes sense when:
- The damage is local: one flashing, one vent boot, one wind-damaged patch
- The shingles around it still lie flat and hold their granules
- The roof is well inside its expected life; InterNACHI's chart gives architectural shingles about 30 years and 3-tab about 20
- The deck under the leak is still firm
Replacement makes more sense when leaks keep appearing in new places, shingles curl across whole slopes, or a repair would only buy a season or two. Then the written quote says so and prices both options. Our roof replacement page explains what a full job includes, and the cost guide covers the numbers.
What a repair visit involves
We look at the roof and the attic, trace the entry point, and send a written quote for the fix before doing any work. Repair pricing depends on access, pitch, how much flashing or decking has to come apart to do it properly, and whether matching shingles are still made. Weathered shingles rarely match new ones exactly, so we tell you how visible a patch will be before you agree to it.
A few things sit outside our repair work: skylight units, flat or torch-on sections, and eavestroughs. If your leak traces to one of those, we tell you what we found and why, so you're not paying us to guess.

